[malaki86]

Todays route - fun again:

I picked up a load in Duncan, SC going back to Fairmont, WV.

I start by loading the USARoads map and adding Fairmont, WV as the destination. Hmm - it's showing 1,354 miles and that I'm sitting in NYC. I think, well, it'll update my location as soon as I start moving. Nope - I drove about 5 miles and it still showed me in Manhatten.

I stop, add the destination again but with the Mid-Atlantic map and it shows correctly - 450 miles.

Off I go.

It suggested I-85, I-77, US-19, I-79. That's fine, but not the way I wanted to run: I-26, I-81, US-19/US-460, I-77, US-19, I-79. No problem. Within 10 miles or so, it picked up that route.

When I was about to cross the NC/TN state line, it was showing 368 miles remaining (dead on). I crossed the state line and it loaded the next map - now it's showing 653 miles remaining. Hmmmm

I continue driving without reloading to recalculate. When I approached the TN/VA line on I-81, it was showing 589 miles. Once the Mid-Atlantic mapset loaded, it dropped to the correct mileage of 294 miles remaining.

Sorry - this multi-mapset is a HUGE problem...

I'll continue to post the problems as I experience them.

Edit: I found another problem with the multi-mapset setup. If you're not in a mapset that you have for your home address, the home button is useless. The same goes for Favorites that aren't in the current loaded mapset. There's no way to change the mapset without adding an address first, either.