help with my radio

[stuffu8]

radio reception no good, was good for a few months after the install but know it sucks, one day it just got bad, chris from MO_CO_SO cked his end and from the antenna to computer is good what next? HQCT loadded and the radio unit is made by mocoso.

[salvi]

mocoso only resells the unit, they actually come from Europe. I had to return mine because I was not getting any signal at all. I now have the HDRadio, I get some reception, but it's just not up to par to oem radios.

[stuffu8]

The radio tunner worked for months and then one day went bad!
Maybe after upgraded to the new version of centrafuse???
I have a list of "bugs" to work out one at a time

[salvi]

Was the HQCT reception as good as a regular OEM unit?

[cpufix]

What version of CF are you now using ?
In version 2 the volume level by default is very low, need to modify the radio config file to raise the volume level.

[Jan]

Is it the volume level or is it the reception that you're complaining about?

[stuffu8]

reception is no good , was just as good as oem for a few months but know no good, I am running the new version of CF 2.80? something like that
But let me tell all of you that I am not happy I cant even get the unit to boot up now for two days, will boot in safe mode, but when i do a restart it crashes " no input device" and gos dead, Chris set it up on his bench and it worked fine then we put back in my truck and worked fine for a few Hrs and then crash I have over 2500.00 into the system and I could of put my money into something els, and I have no radio unless the system is running, Think I might pull out and sell, But then I need new dash etc..

[salvi]

Where does the error show? What happens after the error appears?

[stuffu8]

I know that i can post picks.
Can I post video???
Better if you can see it.
When I start up the truck carpc starts to boot, then the M C S sreen, Then the windos flag? Bar below with a metter ??????
Then it gos blank and blue screen with " no input device" and then the monter powers down because, not seen it.
Will boot up insafe mode most of the time.
I am thinking drivers.
We are working on it, just spending a lot of time working out install stuff, and CF stuff, Misc Stuff, And now this.
Thanks

[stuffu8]

??????????????????
Just went out and started the truck up and the carpc worked fine? Only a short time few min.
I did a power down on the pc and then the truck.
Time to rest
Will see what happens tomarrow
Thanks